PET machine infrared heating spares

Wed, 01 Jul 2026 10:38:28 +0800

When your Sidel, Krones, or SIPA blow molder starts drifting on temperature, the heating tunnel is where the problem shows up first. Preforms come out uneven, and the line starts chasing scrap by slowing down. You need an infrared emitter that fits and performs—no guesswork. What matters, technically We supply PET-machine infrared heating spares built around halogen and quartz short-wave emitters, matched to the OEM heating-zone power and voltage. Expect 2400–3600 W, 220–240 V, and standard R7s connectors, with lengths and mounting that match the original lamp profile. The point is stable spectral output and repeatable heating, so the preform skin hits the right temperature without overheating or thinning. On a stretch blow molding line, consistent preform heating is what keeps cycle time honest. Our emitters are engineered for 1:1 parameter matching on blow molders from Sidel, Krones, SIPA, Husky, SACMI, and Nissei ASB, so you swap a lamp without re-tuning the heating curve. So what does that mean on the floor? Fewer temperature excursions, less scrap, and uptime that stays steady. Energy use drops because the emitter comes up to target quickly and holds it without chasing the setpoint. Installation is straightforward, but alignment is where people get tripped up. Even a small mis-seat in the reflector or holder throws off heating uniformity and shortens lamp life. Double-check the exact wattage and length for your machine model and heating zone, and inspect the reflector condition before you swap. Plan on 5,000–8,000 hours of service life depending on line speed and power settings—keep spares aligned with your preventive maintenance windows.

Spares on Warm IR Patio Heater Parts

PET machine infrared heating spares